for data recovery call: 855.366.4232 or request your service here:
This XQD card would just hang the system when it was plugged in. The careful inspection had revealed that some of the pads got detached from the circuit board. In order to get this card back to work, and get access to the data, we had to remove all 4 NAND memory chips. The board pads were cleaned and re-tined with fresh solder. Using a specialized BGA 152 stencil we've rebelled those NAND chips, and repositioned them to the board. Once this procedure was done, we were able to get access to the data on the card.
if you want to ship your failed device to us for data recovery and free evaluation, simply fill out this form:
and send your drive boxed with bubble wrap to this address:
HDD Recovery Services
391 Bank St, Suite 201
Ottawa, ON
K2P 1Y3
Canada
Updated 2019 my gear for soldering:
Green inspection light
Platter extractor:
Momentary foot pedal switch
Vacuum pump
Cleanroom wipes:
Programmer
Quick pogo pin adapter for eepROM
Microscope:
Vacuum chip pickup tool:
Multimeter:
Microscope camera 21mp 60fps 1080P:
JBC precision soldering iron and tweezers:
Hot air station:
Infrared preheater:
Flux dispenser:
BEST Flux:
Wick:
Solder:
Solder paste for BGA reballing:
NAND BGA rebelling stencil
Gloves:
Fume Extractor (mine is no longer available but this is the new version of the same unit) :
Gear for filming:
small camera:
big camera:
Lens on big camera:
this video:
0 Comments